Impecca ITAC10-KSA21 User's Guide download pdf (Page 10)

PREINSTALLATION INSTRUCTIONS:

Please read ALL instructions before installing. We recommend that two people install this product. If a

new electrical outlet is required, have the outlet installed by a qualified electrician before installing unit.

Step 1) Using the following table, find your wall-sleeve brand of your installation. If you cannot find

your your brand of sleeve listed in the table below, you can use whichever one is close in size and

configuration as a guide. There are two important guidelines to keep in mind:

A) The unit itself should be sloped somewhat toward the rear within the sleeve.

The unit should not rest flush with the bottom of a sleeve. Always use the 17" Tapered Spacer Blocks.

C) The unit should always have a sleeve. If you do not already own one, an Impecca Universal Sleeve

Model # ITA-US10 is available from www.impecca.com or your local dealer.

Brand

Dimensions

W x H

x D

Page Brand

Dimensions

W x H

x D

Page

White-Westinghouse

Frigidaire

Carrier (52F Series)

25½” x 15¼” x

16” OR 17½”

OR 22”

Sears/Kenmore

Carrier(51S Series)

25¾“ x 16⅞“

x 18⅝“

General Electric

Hotpoint

26” x 15⅝”

x 15⅞

Fedders

Emerson

26¾”’ x 15¾”

x 15”

Whirlpool

25⅞” x 16½”

x17⅛“

Fedders, Emerson

Friedrich

27 x 16¾”

x 16¾”

Whirlpool

25⅞” x 16½”

x23”

Fedders

Emerson

27” x 16¾”

x19¾”

NOTE: All wall sleeves used to mount the new air conditioner must be in

sound structural condition and have a rear grille that securely attaches to

sleeve, or rear ange that serves as a stop for the air conditioner.

CAUTION: When installation is complete, replacement unit MUST have a

rearward slope as shown.

Step 2) Remove old air conditioner from wall sleeve and prepare wall sleeve as follows:

• Clean interior (do not disturb seals).

• Wall sleeve must be securely fastened in wall before installing air conditioner.

• Drive more nails or screws through sleeve, into wall, if needed.

• Repair paint if needed.

Step 3) Remove old air conditioner from wall sleeve and prepare wall sleeve as follows:

If a grounding wire is not already place, drill a 1/8 clearance hole for the grounding screw through left side

of wall sleeve, in a clear area about 3 inches maximum back from front edge of sleeve, using the grounding

screw and toothed washer.

Pull loose end of ground wire out front of sleeve, and temporarily bend it down and around lower edge of

sleeve. This ground wire will later be attached to frame of air conditioner once it is installed.

Step 4) Begin specic wall sleeve preparations based on the instructions referenced in the above table.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 49 50

Comments to this Manuals

No comments

Impecca ITAC10-KSA21 User's Guide Page 10

Comments to this Manuals

Related products and manuals for Barbecues & grills Impecca ITAC10-KSA21